| Components |

| 1. Sunroof motor assembly 2. Sunroof sub frame assembly 3. Sunroof drip link 4. Sunroof seal tape | 5. Sunroof drip rail 6. Sunroof sunshade assembly 7. Sunroof glass panel assembly 8. Sunroof deflector assembly |
| Adjustment |
| 1. | Inspect the step height between the roof panel (A) and the glass weatherstrip (B) and then adjust it if necessary.
|
| 2. | Adjust the height of the glass by slightly loosening the screws (A).
|
| 1. | After initial vehicle assembly. |
| 2. | If the initial value is erased or damaged because of short power electric discharge during operation. |
| 3. | After using the manual handle. |
| 1. | Use
the sunroof emergency handle to close or open the sunroof manually if
the sunroof cannot be closed electronically due to motor or controller
electrical malfunction.
|
| 2. | If needed, initialize the sunroof according to the initialization method. Whenever
the vehicle battery is disconnected or discharged, or using the
emergency handle to operate the sunroof, the sunroof system needs to be
reset as follows:
|
Components and components location Component Location 1. Inside rear view mirror Repair procedures Replacement Put on gloves to protect your hands.
Components and components location Components 1. Sunroof glass Repair procedures Replacement Put on gloves to protect your hands.
Schematic diagrams Circuit Diagram Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the crash pad side switch (A) after loosening the mounting screws.
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp assembly (A) after pressing the locking pin. 3. Disconnect the license lamp connector (A). 4. Remove the license lamp bulb (B) after removing the license lamp socket (A).