Kia Picanto (JA): Body (Interior and Exterior) / Crash Pad
Components and components location
| Components |
| 1. Cowl cross bar assembly 2. Main wiring harness 3. Main crash pad assembly 4. Side air vent duct assembly [RH] 5. Crash pad center lower panel assembly 6. Crash pad center fascia garnish 7. Glove box complete | 8. Heater control assembly 9. Center fascia panel assembly 10. Audio unit assembly 11. Cluster fascia upper panel assembly 12. Instrument cluster assembly 13. Side air vant duct assembly [LH] |
- Cluster Fascia Panel
- Center Fascia Panel
- Crash Pad Lower Panel
- Glove Box Housing
- Steering Column Shroud Panel
- Crach Pad Center Panel
- Main Crash Pad Assembly
- Cowl Cross Bar Assembly
Components and components location Component Location 1. Cowl top cover Repair procedures Replacement Put on gloves to protect your hands.
Components and components location Component Location 1. Cluster fascia panel assembly Repair procedures Replacement Put on gloves to protect your hands.
Other information:
Kia Picanto (JA) 2017-2025 Service & Repair Manual: Map Lamp
Repair procedures Removal • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Kia Picanto (JA) 2017-2025 Service & Repair Manual: Blower Resistor (Manual)
Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.
Categories
- Manuals Home
- Kia Picanto Owners Manual
- Kia Picanto Service Manual
- Maintenance
- Engine Electrical System
- Immobilizer System
- New on site
- Most important about car
