Kia Picanto (JA): Crash Pad / Cluster Fascia Panel

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel

Components and components location

Component Location

1. Cluster fascia panel assembly


Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Be careful not to bend or scratch the trim and panels.
1.
Remove the cluster fascia panel (A) by using a remover.

2.
Install in the reverse order of removal.
   
Replace any damaged clips.

    Components and components location Components 1. Cowl cross bar assembly 2. Main wiring harness 3. Main crash pad assembly 4. Side air vent duct assembly [RH] 5.

    Components and components location Component Location 1. Center fascia panel assembly Repair procedures Replacement    Put on gloves to protect your hands.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: License Lamps

    Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp assembly (A) after pressing the locking pin. 3. Disconnect the license lamp connector (A). 4. Remove the license lamp bulb (B) after removing the license lamp socket (A).

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

    Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0161