Kia Picanto (JA): Rear Door / Rear Door Window Glass

Components and components location

Component Location

1. Rear door window glass


Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Be careful not to bend or scratch the trim and panels.
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Separate the inside handle (A) after loosening the mounting screw.

3.
Remove the front door inside handle (B) after disconnecting the cable (A).

4.
Remove the rear door trim mounting bracket (A) after loosening the screws.

5.
Disconnect the rear door speaker connector (A), and then remove the wiring mounting clips.

6.
Remove the front door trim seal (A).

7.
Remove the front door belt inside weather strip (A).

8.
Remove the front door belt outside weather strip (A).

9.
Separate the door side weatherstrip (A).

10.
Remove the quarter fixed glass & molding (A) after loosening the mounting screw and bolts.

11.
Remove the door window glass after sliding it in the direction of the arrow.

12.
Install in the reverse order of removal.
   
Check that glass operation is normal.
Check the damage glass channel, and replace if necessary.
Adjust glass if necessary.

    Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

    Components and components location Component Location 1. Rear door module Repair procedures Replacement    Put on gloves to protect your hands.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Headlamps

    Description and operation Description BI-FUNCTION 1. Definition – A headlamp with integrated functions of high and low beam – The light is controlled by rotating the shield inserted to the lens.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Front Fog Lamps

    Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the front bumper assembly. (Refer to Body - "Front Bumper Assembly") 3.Remove the front fog lamp assembly (A) after loosening the mounting screws.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0212