Kia Picanto (JA): Rear Door / Rear Door Inside Handle

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Body (Interior and Exterior) / Rear Door / Rear Door Inside Handle

Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Be careful not to bend or scratch the trim and panels.
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Separate the rear door inside handle (A) after loosening the mounting screws.

3.
Remove the rear door inside handle (B) after disconnection the cable (B).

4.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Make sure the door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.

    Components and components location Component Location 1. Rear door trim Repair procedures Replacement    Put on gloves to protect your hands.

    Components and components location Component Location 1. Rear door window glass Repair procedures Replacement    Put on gloves to protect your hands.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Unit

    Components and components location Component Location 1. Blower Unit Components 1. Intake Actuator 2. Intake Case [Lower] 3. Air Filter 4. FET 5. Resister 6. Intake Seal 7. Intake Case [Upper] 8. Intake Door Assembly 9. Anti Noise Pad 10.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Power Mosfet

    Repair procedures Inspection 1.Ignition "ON" 2.Manually operate the control switch and measure the voltage of blower motor. 3.Select the control switch to raise voltage until high speed. Fan Motor Voltage ManualFirst speed3.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0212