Kia Picanto JA: Body Side Molding / Rear Wheel Guard

Kia Picanto (JA) 2017-{YEAR} Service & Repair Manual / Body (Interior and Exterior) / Body Side Molding / Rear Wheel Guard

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the rear tire.

2.	Remove the rear wheel guard (A), after loosening the mounting clips and nuts.

Install in the reverse order of removal.

Replace any damaged clips.

Front Wheel Guard

Repair procedures Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pieces without marring the surface...

Front Mud Guard

Repair procedures Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pieces without marring the surface...

Other information:

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Positive Crankcase Ventilation (PCV) Valve

Description and operation Operation Principle Repair procedures Removal 1. Disconnect the vapor hose (A). 2. Remove the PCV valve (B). PCV valve : 1.89 - 2.84 N·m (0.19 - 0.29 kgf·m, 1.40 - 2.09 lb·ft) Inspection 1...

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Brake System

Specifications Specifications Item Specification Master cylinder Type Single Cylinder I.D. Ø 20.64 mm (0.812 in) Piston stroke 33±1 mm (1.29 ± 0.039 in) Fluid level switch Provided Brake booster Type 9" Single Boosting ratio 7...

Categories

Windshield defrosting and defogging

WARNING

Windshield heating

Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this case, set the mode selection knob or button to the position and fan speed control knob or button to the lower speed.

For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed. If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position. Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows. Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.