Kia Picanto (JA): Rear Bumper / Rear Bumper beam Assembly

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper beam Assembly

Components and components location

Component Location

1. Rear bumper beam assembly

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Assembly")

2.	Disconnect the rear bumper beam mounting wiring harness (A).

3.	Remove the rear smart key antenna (A) after loosening the mounting screws.

4.	Disconnect the exension wiring mounting clip (A).

5.	Remove the rear bumper beam assembly (A) after loosening the mounting clips.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

❮Rear Bumper Assembly

Components and components location Component Location 1. Rear bumper cover Repair procedures Replacement Put on gloves to protect your hands.

Rear Door❯

Components and components location Components 1. Rear door trim assembly 2. Rear door trim mounting bracket 3. Rear door panel complete 4.

Other information:

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Power Window Switch

Components and components location Components Driver Power Window Switch Connector Pin Information [All Manual / Auto Down Type] (LHD) No. Description No.

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Motor