Kia Picanto (JA): Driving your vehicle / Radar type autonomous emergency braking

Kia Picanto (JA) 2017-2026 Owner's Manual / Driving your vehicle / Radar type autonomous emergency braking

The AEB system is to reduce or to avoid accident risk. It recognizes the distance from the vehicle ahead through the sensors (i.e. radar), and, if necessary, warns the driver or applies emergency braking of accident risk with the warning message or the warning alarms.

❈ Radar type AEB system does not operate for pedestrians in front.

WARNING

Take the following precautions when using the Autonomous Emergency Braking (AEB):

  • This system is only a supplemental system and it is not intended to, nor does it replace the need for extreme care and attention of the driver. The sensing range and objects detectable by the sensors are limited. Pay attention to the road conditions at all times.
  • NEVER drive too fast in accordance with the road conditions or while cornering.
  • Always drive cautiously to prevent unexpected and sudden situations from occurring. AEB does not stop the vehicle completely and does not avoid collisions.

You can set the speed limit when you do not want to drive over a specific speed. If you drive over the preset speed limit, the warning system operates (set speed limit will blink and chime will sound) until the vehicle speed returns within the speed limit.

System setting The driver can activate the AEB by placing the ignition switch to the ON position and by selecting 'User Settings', 'Driving Assist', and 'Autonomous Emergency Braking System'.

Other information:

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Front Washer Motor

Repair procedures Inspection Front Washer Motor 1.With the washer motor connected to the reservoir tank, fill the reservoir tank with water.    • Before filling the reservoir tank with water, check the filter for foreign material or contamination.

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.

Categories

 
Copyright © 2026 www.kpicanto.com - 0.021