Kia Picanto (JA): Evaporative Emission Control System / Fuel Filler Cap

Description and operation

Description
A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap and the filler neck flange contact each other, the ratchet produces a loud clicking noise indicating the seal has been set.

    Specifications Specification Item Specification Coil Resistance (Ω) 18.

    Description and operation Description Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Mode Control Actuator

    Components and components location Component Location 1. Mode Control Actuator Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

    Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0192