Kia Picanto (JA): Manual Transaxle System / Back-up Lamp Switch

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Manual Transaxle System / Manual Transaxle System / Back-up Lamp Switch

Specifications

Item	Specified
Type	ON/OFF
Operating condition	Reverse gear
Operating voltage	10V - 15V
Operating temperatures	-30°C to 100°C [-30°F to 212°F]"

Components and components location

Component Location

1. Back-up lamp switch

Description and operation

Description

•	Detects the shift operation to the reverse gear.

•	When the transaxle is in the reverse condition, the reverse shift rug turns the back-up lamp switch onby pressing a shaft part of the switch.

Repair procedures

Inspection

1.	Remove the battery and battery tray. G 1.0 T-GDI KAPPA (Refer to Engine Electrical System - "Battery")

2.	Disconnect the back up lamp switch connector (A).

3.	Check the continuity between power terminal and signal terminal.

Removal

1.	Remove the battery and battery tray. G 1.0 T-GDI KAPPA (Refer to Engine Electrical System - "Battery")

2.	Disconnect the back-up lamp switch connector (A).

Remove the back up lamp switch (A).

Tightening torque :

39.2 - 58.9 N·m (4.0 - 6.0 kgf·m, 28.9 - 43.4 lb·ft)

Installation

1.	Install in the reverse order of removal.

The back-up lamp switch must be replaced with new one. (Do not reuse it.)

❮Manual Transaxle

Components and components location Components 1. Control shaft complete 2. Control cable bracket 3. Transaxle support bracket 4. Roll rod bracket 5.

Neutral Switch❯

Specifications Specifications Item Specified Type ON / OFF Operating condition Neutral gear Operating voltage 10 V - 15 V Operating temperature -30°C to 100°C (-30°F to 212°F) Components and components location Component Location 1.

Other information:

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Headlamp Leveling Switch

Schematic diagrams Circuit Diagram Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the crash pad side switch (A) after loosening the mounting screws.

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Immobilizer Control Unit

Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly") 3.Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a bolt.