Kia Picanto: Interior light / Map lamp/Room lamp
• (1) : Press the lamps to turn the front map lamps on and off.
• 
(2) :
- The map lamp and
room lamp comes on
when a door is
opened. The lamps go
out after approximately
30 seconds.
- The map lamp and
room lamp comes on
for approximately
30 seconds when
doors are unlocked
with a transmitter or
smart key as long as
the doors are not
opened.
- The map lamp and
room lamp will stay
on for approximately
20 minutes if a door
is opened with the ignition
switch in the
ACC or LOCK/OFF position.
- The map lamp and
room lamp will stay
on continuously if the
door is opened with
the ignition switch in
the ON position.
- The map lamp and
room lamp will go out
immediately if the ignition
switch is
changed to the ON
position or all doors
are locked.
- To turn off the DOOR
mode, press the
DOOR button (2) once
again (not pressed).
NOTICE
The DOOR mode and ROOM mode can not be selected at a time.
• 
(3) :
Press this switch to
turn the front map
lamps on.
• 
(4) : Press this switch to
turn the front map
lamps off.
Interior light
CAUTION
Do not use the interior lights for extended
periods when the engine is
not running.
It may cause battery discharge.
WARNING
Do not use the interior lights when
driving in the dark. ...
Luggage room lamp
The luggage room lamp comes on when
the tailgate is opened.
CAUTION
The luggage room lamp comes on as
long as the tailgate opens. To prevent
unnecessary charging system
drain, close the ta ...
Other information:
Kia Picanto JA 2017-2025 Owner's Manual: Smart key precautions
NOTICE If, for some reason, you happen to lose your smart key, you will not be able to start the engine. Tow the vehicle, if necessary, contact a professional workshop. Kia recommends to contact an authorized Kia dealer/service partner. A maximum of 2 smart keys can be reg ...
Kia Picanto JA 2017-2025 Service & Repair Manual: Vacuum Pump
Repair procedures Removal and Installation 1.Disconnect the battery negative terminal. 2.Disconnect the wiring connectors and harness clamps and remove the connector brackets around the vacuum pump. 3.Remove the air cleaner assembly. (Refer to Intake and Exhaust System - "Air C ...
