Kia Picanto (JA): Interior Trim / Rear Transverse Trim

Components and components location

Component Location

1. Rear transverse trim


Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Be careful not to bend or scratch the trim and panels.
1.
Remove the luggage board (A).

2.
Disconnect the tailgate weatherstrip.
3.
Remove the rear transverse trim (A).

4.
Install in the reverse order of removal.
   
Make sure that the connector is plugged in properly.

    Components and components location Component Location 1. Center pillar lower trim 2. Center pillar upper trim Repair procedures Replacement    Put on gloves to protect your hands.

    Components and components location Component Location 1. Luggage side trim Repair procedures Replacement    Put on gloves to protect your hands.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Antenna Coil

    Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the steering column upper and lower shroud panel. (Refer to Body - "Steering Column Shroud Panel") 4.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Map Lamp

    Repair procedures Removal    • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0284