| Component Location |

| 1. Center pillar lower trim | 2. Center pillar upper trim |
| Replacement |
Put on gloves to protect your hands. |
|
| 1. | Remove the front door scuff trim by using a remover.
|
| 2. | Remove the rear door scuff trim by using a remover.
|
| 3. | Remove the seat belt (B) from the EFD system.
|
| 4. | remove the center pillar lower trim (A) by using a remover.
|
| 5. | Install in the reverse order of removal.
|
| 1. | Remove the front door scuff trim by using a remover.
|
| 2. | Remove the rear door scuff trim by using a remover.
|
| 3. | Remove the seat belt (B) from the EFD system.
|
| 4. | Remove the center pillar lower trim (A) by using a remover.
|
| 5. | Remove the center pillar upper trim (A).
|
| 6. | Install in the reverse order of removal.
|
Components and components location Component Location 1. Front pillar trim Repair procedures Replacement Put on gloves to protect your hands.
Components and components location Component Location 1. Rear transverse trim Repair procedures Replacement Put on gloves to protect your hands.
Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. Rear Wiper & Washer Switch[LHD] [RHD] Inspection (With KDS/GDS) 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).
Components and components location Component Location 1. Temerature Control Actuator Description and operation Description 1. Heater unit includes mode control actuator and temperature control actuator. 2. Temperature control actuator is located at the heater unit.