| Component Location |

| 1. Rear door trim |
| Replacement |
Put on gloves to protect your hands. |
|
| 1. | Remove the rear door delta inner cover (A) using a remover.
|
| 2. | Loosen the screw (B) after opening the rear door pull handle cap (A).
|
| 3. | Remove the rear door trim (A).
|
| 4. | Disconnect the power window switch connector (A).
|
| 5. | Install in the reverse order of removal.
|
Components and components location Components 1. Rear door trim assembly 2. Rear door trim mounting bracket 3. Rear door panel complete 4.
Repair procedures Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp assembly (A) after pressing the locking pin. 3. Disconnect the license lamp connector (A). 4. Remove the license lamp bulb (B) after removing the license lamp socket (A).
Components and components location Component Location 1. Intake Actuator Description and operation Description 1. The intake actuator is located at the blower unit. 2. It regulates the intake door by signal from control unit.