| Components |

| 1. Side repeater lamp |
| Inspection |
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the front door quadrant inner cover (A).
|
| 3. | Disconnect the tweeter speaker connector (A).
|
| 4. | Disconnect the power door mirror connector from the harness.
|
| 5. | Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly. [Mirror Control (LH/RT)]
[Mirror Heater]
[Side Repeater Lamp]
[Folding Mirror]
|
Components and components location Component Schematic diagrams Circuit Diagram [Folding Mirror Type] [Non-Folding Mirror Type] Repair procedures Inspection 1.
Components and components location Component Location 1. Driver power window switch 2. Assist power window switch 3. Rear power window switch 4.
Components and components location Component Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, separate the map lamp lens (A) from the map lamp. 3. Remove the map lamp (A) after loosening the screws.
Repair procedures Inspection 1.Ignition "ON" 2.Manually operate the control switch and measure the voltage of blower motor. 3.Select the control switch to raise voltage until high speed. Fan Motor Voltage ManualFirst speed3.