| Component Location |

| 1. Rear bumper beam assembly |
| Replacement |
Put on gloves to protect your hands. |
|
| 1. | Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Assembly")
|
| 2. | Disconnect the rear bumper beam mounting wiring harness (A).
|
| 3. | Remove the rear smart key antenna (A) after loosening the mounting screws.
|
| 4. | Disconnect the exension wiring mounting clip (A).
|
| 5. | Remove the rear bumper beam assembly (A) after loosening the mounting clips.
|
| 6. | Install in the reverse order of removal.
|
Components and components location Component Location 1. Rear bumper cover Repair procedures Replacement Put on gloves to protect your hands.
Components and components location Components 1. Rear door trim assembly 2. Rear door trim mounting bracket 3. Rear door panel complete 4.
Components and components location Component Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, separate the map lamp lens (A) from the map lamp. 3. Remove the map lamp (A) after loosening the screws.
Schematic diagrams Circuit Diagram Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the crash pad side switch (A) after loosening the mounting screws.