Kia Picanto (JA): Drive Belt System / Drive Belt Tensioner

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Engine Mechanical System / Drive Belt System / Drive Belt Tensioner

Repair procedures

Removal and Installation
1.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
2.
Remove the drive belt.
(Refer to Drive Belt System - "Drive Belt")
3.
Remove the drive belt tensioner (A).
Tightening torque :
19.6 - 26.5 N·m (2.0 - 2.7 kgf·m, 14.5 - 19.5 lb·ft)

4.
Install in the reverse order of removal.
Inspection
Check the belt tensioner for excessive foreign substances, crack, damage or sticking of pivot shaft. Replace if necessary.

    Repair procedures Removal and Installation 1.Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 2.

    Repair procedures Removal and Installation 1.Remove the engine room under cover and RH side cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 2.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Front Wiper Motor

    Components and components location Component Location 1. Cap 2. Nut 3. Wiper arm & blade 4. Cowl top cover 5. Bolt 6. Wiper motor & linkage assembly 7. Wiper motor connector Repair procedures Removal 1.Disconnect the negative (-) battery terminal.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

    Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0148