Kia Picanto JA: Engine Mechanical System / Engine And Transaxle Assembly

Kia Picanto (JA) 2017-{YEAR} Service & Repair Manual / Engine Mechanical System / Engine And Transaxle Assembly

Crankshaft Damper Pulley

Repair procedures Removal and Installation 1.Remove the engine room under cover and RH side cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 2...

Engine Room Under Cover

Repair procedures Removal and Installation Engine Room Under Cover 1. Remove the engine room under cover (A). Tightening torque : 7...

Other information:

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Emergency Signal System


Description and operation Description Introduction of quick brake warning system (ESS) In case of quick brake by driver, the brake lamp or turn signal is blinked to warn against the vehicle at rear. 1. Basic function (Blinking the brake lamp/emergency lamp) – Operation condition: In case of quick brake or operation of ABS above in a certain speed – Releasing condition: In case of stopping the quick brake or releasing the ABS operation 2...

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Back View Camera System


Components and components location Component Location 1. Back view camera 2. AVN head unit 3. steering angle sensor Description and operation Description 1. To display back of the vehicle to assist the driver, it receives vehicle rearside image signal from the rearview camera and displays it on AVN head unit monitor or LHS of inside rearview mirror...

Categories

Windshield defrosting and defogging

WARNING

Windshield heating

Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this case, set the mode selection knob or button to the position and fan speed control knob or button to the lower speed.

For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed. If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position. Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows. Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.

read more

 
Copyright © 2025 www.kpicanto.com