Kia Picanto JA: Interior Trim / Door Scuff Trim

Kia Picanto (JA) 2017-{YEAR} Service & Repair Manual / Body (Interior and Exterior) / Interior Trim / Door Scuff Trim

Components and components location

Component Location

1. Front door scuff trim

2. Rear door scuff trim

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

[Front Door Scuff Trim]

1.	Using a remover, remove the front door scuff tirm (A).

Install in the reverse order of removal.

Replace any damaged clips.

[Rear Door Scuff Trim]

1.	Remove the rear door scuff trim (A) after loosening the screws.

Install in the reverse order of removal.

Replace any damaged clips.

Interior Trim

Components and components location Components 1. Front pillar trim assembly 2. Front door scuff trim assembly 3. Center pillar upper trim assembly 4...

Cowl Side Trim

Components and components location Component Location 1. Cowl side trim Repair procedures Replacement Put on gloves to protect your hands...

Other information:

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Front Fog Lamps

Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the front bumper assembly. (Refer to Body - "Front Bumper Assembly") 3.Remove the front fog lamp assembly (A) after loosening the mounting screws...

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Center Fascia Panel

Components and components location Component Location 1. Center fascia panel assembly Repair procedures Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pieces without marring the surface...

Categories

Windshield defrosting and defogging

WARNING

Windshield heating

Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this case, set the mode selection knob or button to the position and fan speed control knob or button to the lower speed.

For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed. If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position. Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows. Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.