| Replacement |
| 1. | Loosen the front door checker (A) mounting bolt.
|
| 2. | Detach the clips, and then remove the front door side weatherstrip (A).
|
| 3. | Install in the reverse order of removal.
|
Repair procedures Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Components and components location Component Location 1. Fuel filler door Repair procedures Replacement Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Components and components location Components 1. Door lock/unlock knob cable 2. Door inside handle cable 3. Door latch assembly Repair procedures Inspection • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to
Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.