Kia Picanto (JA): Fuel Delivery System / Filler-Neck Assembly

Repair procedures

Removal
1.
Open the fuel filler door and then remove the filler-neck mounting bolts (A).
Filler-neck assembly mounting bolt:
7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

2.
Left the vehice.
3.
Remove the rear-LH wheel, tire, and the inner wheel house.
4.
Disconnect the fuel filler hose (A), the leveling hose (B) and the ventilation hose (C).

5.
Remove the filler-neck assembly from the vehicle after removing the bracket intallation bolt (A).
Filler-neck assembly bracket mounting bolt:
7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

Installation
1.
Installation is reverse of removal.

    Repair procedures Removal Low Pressure Fuel Line [High pressure fuel pump ↔ Extension fuel line engine room side] 1.Release the residual pressure in fuel line.

    Repair procedures Removal    In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Emergency Call System

    Components and components location Components 1. Head unit (AVN, Audio) 2. Emergency call system button 3. Emergency call system MIC 4. Roof antenna 5. Emergency call unit 6. Supplemental Restraint System Control Module (SRSCM) 7. Emergency call crash pad antenna 8.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Washer Switch

    Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. Rear Wiper & Washer Switch[LHD] [RHD] Inspection (With KDS/GDS) 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0195