Kia Picanto (JA): Cooling System / Water Temperature Control Assembly

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly

Repair procedures

Removal
1.
Disconnect the battery negative terminal.
2.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
3.
Drain the coolant.
(Refer to Cooling System - "Coolant")
4.
Disconnect the radiator upper hose (A).

5.
Disconnect the heater hoses (A).

6.
Disconnect the water hose (A).

7.
Disconnect the wiring connectors and harness clamps. Then, remove the connector brackets around the water temperature assembly.

8.
Remove the water temperature control assembly (A) with gasket (B).
Tightening torque :
19.6 - 26.5 N·m (2.0 - 2.7 kgf·m, 14.5 - 19.5 lb·ft)

   
Do not disassemble the water temperature control assembly (engine coolant stop valve).
9.
Install in the reverse order of removal.
10.
Fill the coolant.
(Refer to Cooling System - "Coolant")
11.
Start the engine and check for leaks.
12.
Recheck the engine coolant level.

    Repair procedures Removal and Installation 1.Disconnect the negative battery terminal. 2.Remove the engine room under cover and RH side cover. (Refer to Engine and Transaxle Assembly - “Engine Room Under Cover”) 3.

    Repair procedures Removal And Installation Thermostat    Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Start/Stop Button

    Components and components location Component Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the steering column shroud lower panel.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Turn Signal Lamp

    Repair procedures Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A) from the mirror holder.    Be careful not to damage the fixing clips (A). 3. Disconnect the heating connectors (A) from the mirror.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0258