Kia Picanto (JA): Starting System / Starter Relay

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Engine Electrical System / Starting System / Starter Relay

Repair procedures

Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).

4.
Check for continuity between the terminals (30 and 87) using an ohmmeter.
Terminal
Resistance
Measure
30 - 87
1MΩ or higher
If there is continuity between the terminals, replace the relay.

5.
Apply 12V to the terminal 85 and ground to the terminal 86 and then check for continuity between the terminals (30 and 87).
Terminal
Resistance
Measure
30 - 87
1Ω or less
If there is no continuity between the terminals, replace the relay.

6.
Install the starter relay.
7.
Install the fuse box cover.

    Specifications Specification Starter ▷12V, 1.2kW : ISG only Item Specification Rated voltage 12 V, 1.

    Description and operation Description The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Emergency Call (eCall) Unit

    Components and components location Component    The eCall unit for AVN is equipped in AVN head unit. Repair procedures Removal    Carry out the Test Mode in the following cases.– Replacing the eCall unit– Replacing the Bac

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Emergency Call (eCall) Button

    Components and components location Component Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, separate the map lamp lens (A) from the map lamp. 3. Remove the map lamp (A) after loosening the screws.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.024