Kia Picanto: Heater / Mode Control Actuator
Components and components location

Description and operation
The mode control actuator is located at the heater unit.
It
adjusts position of mode door by operating mode control actuator based
on signal of A/C control unit. Pressing mode select switch makes the
mode control actuator shift in order of vent→ B/L → floor → mix.
Repair procedures
2. | Disconnect the connector of mode control actuator. |
3. | 3.
Verify that the mode control actuator operates to the defrost mode when
connecting 12V to the terminal 3and grounding terminal 4. |
4. | Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

1. - 2. - 3. Defrost mode 4. Vent mode
| 5. Sensor ground 6. Feedback signal 7. Sesonr (+5V)
|
|
5. | Check the voltage between terminals 6 and 7.
Door position
|
Voltage (5-6)
|
Error detecting
| Vent
| 0.45 ± 0.15V
| Low voltage :0.1V or less High voltage :4.9V or more
| Defrost
| 4.55 ± 0.15V
|
It will feedback current position of actuator to controls. |
6. | If the measured voltage is not specification, substitute with a known-good mode control actuator and check for proper operation. |
7. | If the problem is corrected, replace the mode control actuator. |
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
|
3. | Disconnect the connector (A) and then remove the mode control actuator (B) after loosening the mounting screws
 |
4. | Install in the reverse order of removal. |
Components and components location
Component Location
1. Temerature Control Actuator
Description and operation
Description
1. Heater unit includes mode control actuator and ...
Repair procedures
Replacement
1.Disconnect the negative (-) battery terminal.
2.Remove the heater unit.
(Refer to Heater - "Heater Unit")
3.Remove the heater core cover (A) a ...
Other information:
1. Detach the speed restriction label
(1) from the sealant bottle (2), and
place it in a highly visible place inside
the vehicle such as on the
steering wheel to remind the driver
not to drive too fast.
Carefully follow below steps
2. Shake the sealant bottle.
3. Connect the filling ...
Components and components location
Components
[Kappa 1.0 MPI / FFV, Kappa 1.2 MPI]
1. Clutch pedal assembly 2. Clutch cable
[Kappa 1.0 T-GDI]
1. Clutch pedal assembly 2. Ignition lock and clutch switch 3. Master cylinder 4. Clutch regulator 5. Clutch tube
Repair proced ...