| Removal |
|
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Using a screwdriver or remover, separate the map lamp lens (A) from the map lamp.
|
| 3. | Remove the map lamp (A) after loosening the screws.
|
| 4. | Remove the map lamp assembly (B) after disconnecting the map lamp connector (A).
|
| 1. | Using a screwdriver or remover, separate the map lamp lens (A) from the map lamp.
|
| 2. | Disconnect the map lamp bulb (A).
|
| Installation |
| 1. | Connect the map lamp connector. |
| 2. | Install the map lamp. |
| 3. | Install the map lamp lens. |
| 4. | Connect the negative (-) battery terminal. |
Repair procedures Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A) from the mirror holder.
Repair procedures Inspection 1.Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. No.
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp assembly (A) after pressing the locking pin. 3. Disconnect the license lamp connector (A). 4. Remove the license lamp bulb (B) after removing the license lamp socket (A).
Components and components location Component Location 1. Blower Unit Components 1. Intake Actuator 2. Intake Case [Lower] 3. Air Filter 4. FET 5. Resister 6. Intake Seal 7. Intake Case [Upper] 8. Intake Door Assembly 9. Anti Noise Pad 10.