Kia Picanto (JA): Cruise control system / To set cruise control speed
1. Press the cruise
/ CRUISE
button
on the steering wheel, to turn the
system on. The cruise indicator
light will illuminate.
2. Accelerate to the desired speed, which must be more than 30 km/h (20 mph).
NOTICE
Manual transaxle
For manual transaxle vehicles, you should depress the brake pedal at least once to set the cruise control after starting the engine.
3. Move the lever down (to SET-), and release it at the desired speed. The cruise set indicator light will illuminate. Release the accelerator pedal at the same time. The desired speed will automatically be maintained.
On a steep grade, the vehicle may slow down or speed up slightly while going downhill.
O / CANCEL: Cancels cruise control operation. CRUISE / : Turns cruise control system on or off. RES+: Resumes or increases cruise control speed.
Follow either of these procedures: Move the lever up (to RES+) and hold it. Your vehicle will accelerate. Release the lever at the speed you want.
Other information:
Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Washer Switch
Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. Rear Wiper & Washer Switch[LHD] [RHD] Inspection (With KDS/GDS) 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).
Kia Picanto (JA) 2017-2026 Service & Repair Manual: Smart Key
Repair procedures Smart Key Smart Key Code Saving 1. Connect the DLC cable of KDS/GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on KDS/GDS. 2. Select the vehicle model and then do "Smart key code saving".
Categories
- Manuals Home
- Kia Picanto Owners Manual
- Kia Picanto Service Manual
- Coolant
- Automatic Transaxle Fluid
- Cooling System
- New on site
- Most important about car
