Kia Picanto JA: Body Electrical System / Power Door Mirrors

Kia Picanto (JA) 2017-{YEAR} Service & Repair Manual / Body Electrical System / Power Door Mirrors

Components and components location
Component Location

1. Power door mirror
2. Power door mirror switch
3. Power folding mirror switch

Power Door Lock Switch

Repair procedures Inspection 1.Check for continuity between the terminals. If there is an abnormality, replace the switch. Removal    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Power Door Mirror Switch

Components and components location Component Schematic diagrams Circuit Diagram [Folding Mirror Type] [Non-Folding Mirror Type] Repair procedures Inspection 1...

Other information:

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Windshield Wiper-Washer Switch


Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the steering column upper and lower shrouds after loosening the screws. (Refer to Body - "Steering Column Shroud Panal") 3.Disconnect the wiper switch / washer switch connector (A)...

Kia Picanto (JA) 2017-2025 Owner's Manual: Engine oil


Checking the engine oil level 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan...

Categories

Windshield defrosting and defogging

WARNING

Windshield heating

Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this case, set the mode selection knob or button to the position and fan speed control knob or button to the lower speed.

For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed. If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position. Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows. Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.

read more

 
Copyright © 2025 www.kpicanto.com