Kia Picanto (JA): Engine start/stop button / Stopping the Engine

Manual Transaxle

1. When the vehicle is stationary, depress the clutch and brake pedal at the same time.

2. With the clutch and brake pedal depressed, shift the shift lever into N (Neutral).

3. With the brake pedal depressed, apply the parking brake.

4. Press the ignition switch and turn off the engine.

Automatic Transaxle

1. When the vehicle is stationary, depress the brake pedal.

2. With the brake pedal depressed, shift the shift lever into P (Park).

3. With the brake pedal depressed, apply the parking brake.

4. Press the ignition switch and turn off the engine.

CAUTION

  • Try not to idle the vehicle at high speeds just before turning off the engine.
  • When the vehicle is parked on a slope, make sure the transaxle is shifted into P (Park) for automatic transaxle. For manual transaxle, shift the transaxle into 1 (First) gear on uphill grades, R (Reverse) on downhill grades and place chocks under the tires.
  • For automatic transaxle vehicles, make sure the shift lever is shifted into P (Park) when parking the vehicle. If not, the vehicle might move from external impacts.

WARNING

Do not park the vehicle on a steep hill. It may cause the vehicle to move.

    WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots, etc.) may interfere with your ability to use the brake and accelerator pedal.

    Your vehicle may be equipped with the ISG system, which reduces fuel consumption by automatically shutting down the engine, when the vehicle is at a standstill.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Electro Chromic Inside Rear View Mirror

    Components and components location Components Description and operation Description The ECM (Electro Chromatic inside rear view Mirror) is one that automatically dims to protect the driver’s eyes when it senses light reflecting from the car behind.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Glass Defogger Printed Heater

    Repair procedures Inspection    • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circuits.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0441