| Replacement |
| 1. | Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
|
| 2. | Remove the rear door belt outside weatherstrip (A) after loosening the mounting screw.
|
| 3. | Install in the reverse order of removal.
|
Repair procedures Replacement 1. Pull down the rear door window glass to the lowest level by pressing the power window glass switch. 2. Remove the rear door belt outside weatherstrip (A) after loosening the mounting screw.
Repair procedures Replacement 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 19.6 - 29.4 N·m (2.
Repair procedures Inspection 1.Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. No. Description No.
Components and components location Components Control Panel Connector pin function No. Connector A Connector B 1 Battery PAB IGN1 2 ISG Battery (+) PAB On signal 3 Illumination (+) PAB Off signal 4 Sensor REF (+5V) - 5 Mode control actua