Kia Picanto JA: Windows / Manual windows

Kia Picanto (JA) 2017-{YEAR} Owner's Manual / Features of your vehicle / Windows / Manual windows

To raise or lower the window, turn the window regulator handle clockwise or counterclockwise.

WARNING

When opening or closing the windows, make sure your passenger's arms, hands and body are safely out of the way.

Power windows

The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door's window. The driver has a power window lock switch which can block the operation of rear passenger windows...

Hood

Opening the hood 1. Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) position for automatic transaxle and to the 1st(First) gear or R(Reverse) for manual transaxle, and setting the parking brake...

Other information:

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Lighting System

Specifications Specification Item Type Bulb Watt (W) Front Headlamp Halogen (Position lamp) Low/High H4 LL 55/60 Turn signal lamp PY21WLL 21 Position lamp W5WLL 5 Halogen (Position lamp + DRL) Low/High HB3 (9005HL+) 60 Turn signal lamp LED LED Position lamp LED LED Daytime Running Light (DRL) LED LED Front fog lamp HB4 51 Turn signal lamp (Side) WY5W 5 Door mirror turn signal lamp LED LED Rear Rear combination lamp Bulb Type Tail lamp W5WLL 5 Tail / Stop lamp P21/5WLL 21 Turn signal lamp PY21WLL 21 Back up lamp W16W 16 LED Type Tail lamp LED LED Tail / Stop lamp LED LED Turn signal lamp PY21WLL 21 Back up lamp W16W 16 High mounted stop lamp Bulb Type W5WLL 5 License plate lamp W5WLL 5 Interior Map lamp W10W 10 Room lamp FESTOON 8 Luggage lamp FESTOON 8 Glove box lamp W5W 10 Components and components location Component Location 1 ...

Kia Picanto (JA) 2017-2025 Service & Repair Manual: ETC (Electronic Throttle Control) System

Specifications Specification Sensor Item Opening Percentage (%) Output Voltage (V) [Vref = 5V] TPS1 C.T 8.5 - 11.5 0.43 - 0.58 W.O.T 88 - 96 4...

Categories

Windshield defrosting and defogging

WARNING

Windshield heating

Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this case, set the mode selection knob or button to the position and fan speed control knob or button to the lower speed.

For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed. If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position. Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows. Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.