Kia Picanto (JA): If you have a flat tire (with spare tire) / Jack and tools

The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment. Pull up the luggage box cover to reach this equipment.

1. Jack handle

2. Jack

3. Wheel lug nut wrench

Jacking instructions

The jack is provided for emergency tire changing only.

To prevent the jack from “rattling” while the vehicle is in motion, store it properly.

Follow jacking instructions to reduce the possibility of personal injury.

WARNING

Changing tires

  • Never attempt vehicle repairs in the traffic lanes of a public road or highway.
  • Always move the vehicle completely off the road and onto the shoulder before trying to change a tire. The jack should be used on firm level ground. If you cannot find a firm level place off the road, call a towing service company for assistance.
  • Be sure to use the correct front and rear jacking positions on the vehicle; never use the bumpers or any other part of the vehicle for jacking support.
  • The vehicle can roll off the jack causing serious injury or death.
  • Do not get under a vehicle that is supported by a jack.
  • Do not start or run the engine while the vehicle is on the jack.
  • Do not allow anyone remain in the vehicle while it is on the jack.
  • Make sure any children present are in a secure place away from the road and from the vehicle to be raised with the jack.

    Turn the tire hold-down wing bolt counterclockwise. Store the tire in the reverse order of removal. To prevent the spare tire and tools from “rattling” while the vehicle is in motion, store them properly.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Power Door Locks

    Components and components location Component Location 1. Driver power window switch 2. Assist power window switch 3 . Body Comtrol Module (BCM) 4 . Door lock knob 5 . Tailgate actuator 6. Door latch lock actuator 7 . Door lock/unlock switch 8 .

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

    Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0201