Kia Picanto (JA): Hood / Hood Latch Release Handle

Components and components location

Component Location

1. Hood latch release handle


Repair procedures

Replacement
1.
Using a remover, remove the hood release handle (A).

2.
Install in the reverse order of removal.
   
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.

    Repair procedures Replacement 1. Remove the hood weatherstrip (A).    Be careful not to damage the hood and body. 2. Install in the reverse order of removal.

    Components and components location Component Location 1. Hood lower latch assembly Repair procedures Replacement 1. Disconnect the hood latch connector (A).

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Immobilizer Control Unit

    Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly") 3.Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a bolt.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Washer Switch

    Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. Rear Wiper & Washer Switch[LHD] [RHD] Inspection (With KDS/GDS) 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0288