Kia Picanto (JA): ESC (Electronic Stability Control) System / ESC Control Module

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Brake System / ESC (Electronic Stability Control) System / ESC Control Module

Components and components location

Components

1. ESC control module connector
2. ESC control module

3. ESC bracket

Repair procedures

Removal

1.	Turn ignition OFF and disconnect the negative (-) battery cable.

Remove the brake fluid from the master cylinder reservoir with a syringe.

•	Be sure to completely remove foreign substances from around brake fluid reservoir and cap before opening the reservoir cap. Otherwise, it may cause contamination of brake fluid and deterioration in braking performance.

•	Do not spill brake fluid on the vehicle as it may damage the paint. If brake fluid comes in contact with the paint, wash off immediately with water.

3.	Remove the air cleaner assembly. G 1.0 MPI (Refer to Engine Mechanical System - "Air cleaner") G 1.2 MPI (Refer to Engine Mechanical System - "Air cleaner") F 1.0 MPI (Refer to Engine Mechanical System - "Air cleaner")

4.	Loosen the bolt and then remove the CVVT oil control valve bracket (A) and connector bracket (B).

Disconnect the brake tubes from the ESC by unlocking the nuts counterclockwise with a wrench.

Tightening torque

A : 12.7 - 16.7 N·m (1.3 - 1.7 kgf·m, 9.4 - 12.3 lb·ft)

B : 18.6 - 22.6 N·m (1.9 - 2.3 kgf·m, 13.7 - 16.6 lb·ft)

6.	Disconnect the ESC control module connector.

Loosen the nuts and then remove the ESC control module (HECU).

•	Never attempt to disassemble the ESC.

•	The ABS must be transported and stored in.

•	Never shock to the ABS.

Installation

1.	Install in the reverse order of removal.

2.	After installation, bleed the brake system.

3.	Conduct the Variant coding.

4.	Conduct the Auto Detected Sensor Calibration.

5.	Conduct the Longitudinal G Sensor Calibration.

Diagnostic procedure by using diagnostic device

Perform diagnostic procedure by using diagnostic device as shown below:

Connect self-diagnosis connector (16pins) located under the driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.

Select the "vehicle model" and "ABS/ESC" on GDS vehicle selection screen, then select OK.

[Variant Coding]

[Auto Detected Sensor Calibration]

[Longitudinal G Sensor Calibration]

❮ESC (Electronic Stability Control) System

Components and components location Components 1. ESC control module (HECU) 2. Front wheel speed sensor 3. Rear wheel speed sensor Description and operation Description of ESC Electronic Stability Control (ESC) recognizes critical driving conditions, such as panic reactions in dangerous situations, and stabilizes the vehicle by wheel-individual braking and engine control intervention.

Front Wheel Speed Sensor❯

Repair procedures Removal 1. Remove the wheel tire (A). Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.

Other information:

Kia Picanto (JA) 2017-2026 Service & Repair Manual: License Lamps

Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp assembly (A) after pressing the locking pin. 3. Disconnect the license lamp connector (A). 4. Remove the license lamp bulb (B) after removing the license lamp socket (A).

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Smart Key System