Kia Picanto (JA): Power Train / Battery

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Maintenance / Power Train / Battery

Repair procedures

Inspection
Battery Voltage and Status
Check the battery voltage and status using the battery tester.
Battery Terminal
1.
Move back and forth to check that the battery terminals (A) are loose or corroded.If the terminals are corroded, clean them.

If battery positive connection is loose, disconnect ground(GND) cable first before attempting to remove or tighten plus connection, to prevent personal injury.
2.
If the battery clamp on battery positive (+) terminal is not seated securely:
(1)
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
(2)
Tighten battery clamp (A) on battery positive (+) terminal
Battery positive (+) terminal:
7.8 - 9.8 N·m (0.8 - 1.0 kgf·m, 5.8 - 7.2 lb·ft)

3.
If the battery clamp on battery negative (-) terminal is not seated securely:
(1)
Tighten battery clamp (A) on battery negative (-) terminal.
Battery negative (-) terminal:
4.0 - 6.0 N·m (0.4 - 0.6 kgf·m, 3.0 - 4.4 lb·ft)

Battery Condition
Check the battery for damage or deformation. If severe damage, deformation or leakage is found, replace the battery.

    Repair procedures Inspection Automatic Transaxle Fluid (ATF) Level Check 1. Place the vehicle on a level ground. 2. Start the engine to warm up the ATF.

    Repair procedures Inspection Radiator hoses 1.Check radiator hoses for the following(1)Improper attachment(2)Leaks(3)Cracks(4)Damage(5)Loose connections(6)Chafing(7)Deterioration Coolant level 1.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Power Door Mirror Switch

    Components and components location Component Schematic diagrams Circuit Diagram [Folding Mirror Type] [Non-Folding Mirror Type] Repair procedures Inspection 1.Check for continuity between the terminals in each switch position according to the table.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Smart Key Diagnostic

    Repair procedures Inspection Self Diagnosis With Scan Tool It will be able to diagnose defects of SMART KEY system with KDS/GDS quickly. KDS/GDS can operates actuator forcefully, input/output value monitoring and self diagnosis. The following three features will be major problem in SMART KEY system.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0176