Kia Picanto: Blower / Blower Resistor (Manual)

Kia Picanto JA 2017-2025 Service & Repair Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Resistor (Manual)

Repair procedures

Inspection

1.	Measure terminal - to - terminal resistance of blower resistor.

2.	measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the glove box housing. (Refer to Body - "Glove Box Housing")

3.	Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

4.	Install in the reverse order of removal.

Blower Motor

Repair procedures Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower mot ...

Power Mosfet

Repair procedures Inspection 1.Ignition "ON" 2.Manually operate the control switch and measure the voltage of blower motor. 3.Select the control switch to raise voltage until high speed. ...

Other information:

Kia Picanto JA 2017-2025 Service & Repair Manual: Crankcase Emission Control System

Schematic diagrams Schematic Diagram Repair procedures Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of the PCV v ...

Kia Picanto JA 2017-2025 Service & Repair Manual: Engine Control System

Components and components location Components Location 1. ECM (Engine Control Module) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Boost Pressure Sensor (BPS) 5. Engine Coolant Temperature Sensor (ECTS) 6. Throttle Position Sensor (TPS) [integrated ...