Kia Picanto: Blower / Blower Motor
Repair procedures
1. | Connect the battery voltage and check the blower motor rotation.
 |
2. | If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. |
3. | If the problem is corrected, replace the blower motor. |
1. | Disconnect the negative (-) battery terminal. |
2. | Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.
 |
3. | Install in the reverse order of removal. |
Components and components location
Component Location
1. Blower Unit
Components
1. Intake Actuator 2. Intake Case [Lower] 3. Air Filter 4. FET 5. Resister 6. Intake Seal 7. Intake Cas ...
Repair procedures
Inspection
1.Measure terminal - to - terminal resistance of blower resistor.
2.measured resistance is not within specification, the blower resistor must be replaced. (After re ...
Other information:
Components and components location
Components
1. Front oil seal 2. Timing chain cover & oil pump assembly 3. Timing chain tensioner 4. Timing chain tensioner arm 5. Timing chain 6. Timing chain guide 7. Exhaust CVVT assembly 8. Exhaust camshaft 9. Intake CVVT assembly 10. Intake camsha ...
Repair procedures
Removal
[Kappa 1.0 T-GDI]
1.Remove the engine room under cover.
G 1.0 T-GDI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover")
2.Drain the brake fluid through the bleed plug (A).
Do
not spill brake fluid on th ...