| Inspection |
Tire (pressure & tread wear)Repair procedures Inspection 1. Check the tire pressure. 13(inch) : 230 kPa (33 psi) 14(inch) : 230 kPa (33 psi) 15(inch) : 230 kPa (33 psi) 16(inch) : 230 kPa (33 psi) Tire Rotation Checking For Pull And Wander If the steering pulls to one side, rotate the tires according to the following wheel rotation procedure...
1. After driving approximately 7~10 km (4~6 miles or about 10 minutes), stop at a suitable location. 2. Connect the filling hose (3) of the compressor (clip mounted side) directly and then connect the filling hose (3) (opposite side) to the tire valve...
Repair procedures Replacement 1.Remove the transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle") 2.Remove the flywheel. (Refer to Cylinder Block Assembly - "Flywheel") 3.Remove the rear oil seal (A)...

The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A).
The green arrow indicators on the instrument panel indicate which turn signal is operating. They will self-cancel after a turn is completed.