Kia Picanto (JA): Scheduled maintenance service / Scheduled maintenance service precaution

Follow the Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, follow the Maintenance Under Severe Usage Conditions.

  • Repeated driving short distance of less than 8 km (5 miles) in normal temperature or less than 16 km(10 miles) in freezing temperature
  • Extensive engine idling or low speed driving for long distances
  • Driving on rough, dusty, muddy, unpaved, graveled or salt-spread roads
  • Driving in areas using salt or other corrosive materials or in very cold weather
  • Driving in heavy dust condition
  • Driving in heavy traffic area
  • Driving on uphill, downhill, or mountain road repeatedly
  • Towing a trailer or using a camper, or roof rack
  • Driving as a patrol car, taxi, other commercial use of vehicle towing
  • Driving over 170 km/h (106 mph)
  • Frequently driving in stop-and-go condition

If your vehicle is operated under the above conditions, you should inspect, replace or refill more frequently than the following Normal Maintenance Schedule. After the periods or distance shown in the chart, continue to follow the prescribed maintenance intervals.

    The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Back View Camera System

    Components and components location Component Location 1. Back view camera 2. AVN head unit 3. steering angle sensor Description and operation Description 1. To display back of the vehicle to assist the driver, it receives vehicle rearside image signal from the rearview camera and displays it on AVN head unit monitor

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Parking Assist Sensor

    Components and components location Components Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the rear bumper assembly. (Refer to Body - "Rear Bumper Assembly") 3.Disconnect the connector (A) from the ultrasonic sensor.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.023