Kia Picanto (JA): Body Side Molding / Roof Side Molding

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding

Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a remover, remove the roof side molding (A).
   
Always replace the roof side molding with a new one.

2.
Install in the reverse order of removal.
   
First assemble the clip ⓐ and then assemble the other clips from the ⓐ to ⓖ direction in sequence order.

    Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Glass Defogger Printed Heater

    Repair procedures Inspection    • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circuits.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Mode Control Actuator

    Components and components location Component Location 1. Mode Control Actuator Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0322