Kia Picanto (JA): Interior features / Floor mat anchor(s)

When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.

WARNING

The following must be observed when installing ANY floor mat to the vehicle.

  • Ensure that the floor mats are securely attached to the vehicle's floor mat anchor(s) before driving the vehicle.
  • Do not use ANY floor mat that cannot be firmly attached to the vehicle's floor mat anchors.
  • Do not stack floor mats on top of one another (e.g. all-weather rubber mat on top of a carpeted floor mat). Only a single floor mat should be installed in each position.

IMPORTANT - Your vehicle was manufactured with driver's side floor mat anchors that are designed to securely hold the floor mat in place. To avoid any interference with pedal operation, Kia recommends that only the Kia floor mat designed for use in your vehicle be installed.

    Whenever the battery terminals or related fuses are disconnected, you must reset the time. When the ignition switch is in the ACC or ON position, the clock buttons operate as follows: Setup the clock Hour: Turn the knob to the left (H), will advance the time displayed by one hour.

    CAUTION Do not hang a bag weighing more than 3 kg (7 lbs.). It may cause damage to the shopping bag holder. Do not hang the frail objects when you drive rough road, the objects may be damaged.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Turn Signal Lamp

    Repair procedures Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A) from the mirror holder.    Be careful not to damage the fixing clips (A). 3. Disconnect the heating connectors (A) from the mirror.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: License Lamps

    Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp assembly (A) after pressing the locking pin. 3. Disconnect the license lamp connector (A). 4. Remove the license lamp bulb (B) after removing the license lamp socket (A).

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0328