Kia Picanto (JA): If you have a flat tire (with tire mobility kit) (Type B) / Distributing the sealant

12. Immediately drive approximately 7~10 km (4~6 miles or, about 10 min) to evenly distribute the sealant in the tire.

CAUTION

Do not exceed a speed of 60 km/h (35 miles). If possible, do not fall below a speed of 20 km/h (12 miles). While driving, if you experience any unusual vibration, ride disturbance or noise, reduce your speed and drive with caution until you can safely pull off of the side of the road. Call for road side service or towing.

When you use the Tire Mobility Kit, the wheel may be stained by sealant. When you use the Tire Mobility Kit, the wheel may be stained by sealant. Therefore, remove the wheel stained by sealant and have the vehicle inspected at a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

    1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast.

    1. After driving approximately 7~10 km (4~6 miles or about 10 minutes), stop at a suitable location. 2. Connect the filling hose (3) of the compressor (clip mounted side) directly and then connect the filling hose (3) (opposite side) to the tire valve.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Combination Lamp

    Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the rear combination lamp (A) after loosening the screws. 3.Remove the rear combination lamp packing (A). 4.Disconnect the rear combination lamp connector (A).

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Power Window Switch

    Components and components location Components Driver Power Window Switch Connector Pin Information [All Manual / Auto Down Type] (LHD) No. Description No.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0164