Kia Picanto (JA): Heating,Ventilation, Air Conditioning / Controller
Components and components location Component Location 1. Intake Actuator Description and operation Description 1. The intake actuator is located at the blower unit.
Components and components location Components [NON ISG] Connector pin function No. Connector A Connector B 1 Low Battery 2 Common Illumination (+) 3 Ground HTD 4 Middle (Low) ISG Battery 5 Middle (High) - 6 High Detent out (-) 7 - 8 Sensor REF (+5V) 9 Intake actuator (FRE) 10 Intake actuator (REC) 11 Intake actuator Feedback 12 PAB On signal 13 PAB Off signal 14 Ground 15 Sensor ground 16 Illumination (-) 17 IGN2 18 IGN1 19 PAB IGN1 20 Ambient sensor (+) 21 Evaporator sensor (+) 22 MAX Blower on signal 23 Seat belt reminder 24 Rear left seat belt reminder 25 Rear center seat belt reminder 26 Rear right seat belt reminder 27 - 28 C_CAN (High) 29 C_CAN (Low) 30 Rear deffog switch 31 Blower on signal to Common 32 Ground Repair procedures Replacement 1.
Other information:
Kia Picanto (JA) 2017-2026 Service & Repair Manual: Immobilizer System
Schematic diagrams Circuit Diaram Description and operation Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in addition to the currently available anti-theft systems such as car alarms, the immobilizer system aims to drastically reduce the rate of auto theft.
Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Combination Lamp
Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the rear combination lamp (A) after loosening the screws. 3.Remove the rear combination lamp packing (A). 4.Disconnect the rear combination lamp connector (A).
Categories
- Manuals Home
- Kia Picanto Owners Manual
- Kia Picanto Service Manual
- Engine Mechanical System
- Engine Oil and Filter
- General Information
- New on site
- Most important about car
