Kia Picanto (JA): Maintenance / Climate control air filter

Filter inspection

The climate control air filter should be replaced according to the maintenance schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you replace the climate control air filter, replace it performing the following procedure, and be careful to avoid damaging other components.

1. With the glove box open, lower the glove box by pushing both sides.

2. Remove the climate control air filter cover while pressing the lock on the right side of the cover.

3. Replace the climate control air filter.

4. Reassemble in the reverse order of disassembly.

NOTICE

When replacing the climate control air filter install it properly. Otherwise, the system may produce noise and the effectiveness of the filter may be reduced.

    Filter replacement It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element.

    Blade inspection NOTICE Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Glass Defogger Switch

    Repair procedures Inspection 1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).The diagnostic system (KDS/GDS) provides the following information.(1)Self diagnosis : Checking failure and code number (DTC)(2) Current data : Checking the system input/output data state (3)Actuation

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Heater Core

    Repair procedures Replacement 1.Disconnect the negative (-) battery terminal. 2.Remove the heater unit. (Refer to Heater - "Heater Unit") 3.Remove the heater core cover (A) after loosening the mounting screws. 4.Pull out the heater core (A) from the heater unit.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0194