Kia Picanto (JA): ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor

Description and operation

Description

In order to ensure adequate brake power assistance in every situation, the brake booster is equipped with a partial vacuum sensor. The brake booster vacuum pressure sensor is located beside the brake booster.

Repair procedures

Inspection

1.	Check installation status of BBVPS and Vacuum hose or damage of vacuum hose.

2.	Connect KDS to DLC (Data Link Cable).

3.	Warm up the engine to normal operating temperature.

4.	Monitor "BBVPS" parameter on KDS.

❮Battery sensor

Description and operation Description Vehicles have many control units that consume electricity. Each unit controls its own system based on information from various sensors.

AGM Battery❯

Specifications Specification ▷ AGM50L-DIN Item Specification Capacity [20HR / 5HR] (AH) 50/40 Cold Cranking Amperage (A) 560 (SAE) / 560(EN) Reserve Capacity (Min) 80 • Model type description • Cold Cranking Ampere (CCA): Cold Cranking Amps is a rating used in the battery industry to define a battery's ability to start an engine in cold temperatures.

Other information:

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Wiper Motor

Repair procedures Inspection Rear Wiper Motor 1.Remove the connector from the rear wiper motor. 2.Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively. 3.Check that the motor operates normally.

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Smart Key Diagnostic