Kia Picanto (JA): ISG (Idle Stop and Go) system / Auto start

To restart the engine from idle stop mode

  • Press the clutch pedal when the shift lever is in the N (Neutral) position. (Manual transaxle)
  • Press the brake pedal for auto start. (Automatic transaxle)

The engine will start and the green AUTO STOP indicator ( ) on the instrument cluster will go out. If your vehicle is equipped with a supervision cluster, the notice will illuminate on the LCD display.

The engine will also restart automatically without the driver’s any actions if the following occurs:

- The fan speed of manual climate control system is set above the 3rd position when the air conditioning is on.
- The fan speed of automatic climate control system is set above the 6th position when the air conditioning is on.
- When a certain amount of time has passed with the climate control system on.
- When the defroster is on.
- The brake vacuum pressure is low.
- The battery charging status is low.
- The vehicle speed exceeds 5 km/h.

The green AUTO STOP indicator ( ) on the instrument cluster will blink for 5 seconds.

    To stop the engine in idle stop mode Manual transaxle 1. Decrease the vehicle speed to less than 5 km/h. 2. Shift into N (Neutral) position. 3.

    The ISG system will operate under the following condition: - The driver’s seat belt is fastened. - The driver’s door and hood are closed. - The brake vacuum pressure is adequate.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Glass Defogger Switch

    Repair procedures Inspection 1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).The diagnostic system (KDS/GDS) provides the following information.(1)Self diagnosis : Checking failure and code number (DTC)(2) Current data : Checking the system input/output data state (3)Actuation

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

    Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0195