Kia Picanto (JA): ISG (Idle Stop & Go) System / Hood switch

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Hood switch

Description and operation

Description
The hood switch is included as the influencing factors in the calculation of the ISG function. If the hood is open, the engine must not be started or stopped by the ISG function for safety reasons.

Repair procedures

Inspection
1.
Disconnect the hood switch connector.

2.
Check for continuity between the terminals and ground as shown below.
(Refer to Body - "Hood Latch Assembly")

    Components and components location Component Location 1. Front seat belt buckle Repair procedures Replacement 1.Remove the front seat assembly.

    Specifications Specifications Item Specifications Working voltage DC 12.5V Operating force Initial position : 0.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Back View Camera System

    Components and components location Component Location 1. Back view camera 2. AVN head unit 3. steering angle sensor Description and operation Description 1. To display back of the vehicle to assist the driver, it receives vehicle rearside image signal from the rearview camera and displays it on AVN head unit monitor

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

    Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0207