Kia Picanto: ISG (Idle Stop & Go) System / Seat belt switch

Kia Picanto JA 2017-2025 Service & Repair Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Seat belt switch

Components and components location

Component Location

1. Front seat belt buckle

Repair procedures

Replacement

1.	Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")

2.	Disconnect the front seat belt wiring mounting clips (A).

Remove the front seat belt buckle (A) after loosening the mounting bolt.

Tightening torque :

39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.9 - 39.8 lb·ft)

Install in the reverse order of removal.

•	Make sure that the connector is plugged in properly.

•	Replace any damaged clips.

Door switch

Description and operation Description Via the seat belt/Door switch, the ISG function can detect that the driver has fastened the seat belt/door. If the driver has not fastened the seat be ...

Hood switch

Description and operation Description The hood switch is included as the influencing factors in the calculation of the ISG function. If the hood is open, the engine must not be started or ...

Other information:

Kia Picanto JA 2017-2025 Owner's Manual: Limitation of the system

The AEB is an assistant system for a driver in a certain risky driving condition and it does not take every responsibility for all risks from driving condition. The AEB monitors the driving situations through the radar. Thus, for a situation out of the sensing range, the AEB may not no ...

Kia Picanto JA 2017-2025 Owner's Manual: Curtain air bag

Curtain air bags are located along both sides of the roof rails above the center pillar. They are designed to help protect the heads of the front seat occupants and the rear outboard seat occupants in certain side impact collisions. The curtain air bags are designed to deploy only du ...