Kia Picanto (JA): Maintenance / Air cleaner (Kappa 1.0L MPI(Gasoline,FFV), Kappa 1.2L MPI(Gasoline))

Kia Picanto (JA) 2017-2026 Owner's Manual / Maintenance / Air cleaner (Kappa 1.0L MPI(Gasoline,FFV), Kappa 1.2L MPI(Gasoline))

Filter replacement

It must be replaced when necessary, and should not be washed.

You can clean the filter when inspecting the air cleaner element.

Clean the filter by using compressed air.

1. Loosen the air cleaner cover attaching clips and remove the air cleaner hose.

2. Wipe the inside of the air cleaner hose.

3. Replace the air cleaner filter.

4. Lock the air cleaner hose with the cover attaching clips.

Replace the filter according to the “Maintenance Schedule” on page 8-11. If the vehicle is operated in extremely dusty or sandy areas, replace the element more often than the usual recommended intervals. (Refer to “Maintenance under severe usage conditions” on page 8-17.)

CAUTION

  • Do not drive with the air cleaner removed; this will result in excessive engine wear.
  • When removing the air cleaner filter, be careful that dust or dirt does not enter the air intake, or damage may result.
  • Use parts for replacement from a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

    Checking the parking brake Check the stroke of the parking brake by counting the number of “clicks’’ heard while fully applying it from the released position.

    Filter replacement It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Immobilizer Control Unit

    Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly") 3.Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a bolt.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Power Door Lock Switch

    Repair procedures Inspection 1.Check for continuity between the terminals. If there is an abnormality, replace the switch. Removal    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.016