Kia Picanto (JA): Wipers and washers / Windshield washers (front)

In the O (Off) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.

Use this function when the windshield is dirty.

The spray and wiper operation will continue until you release the lever.

If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.

The reservoir filler neck is located in the front of the engine compartment on the passenger side.

CAUTION

To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.

WARNING

Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on the windshield and obscure your vision.

CAUTION

  • To prevent possible damage to the wipers or windshield, do not operate the wipers when the windshield is dry.
  • To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
  • To prevent damage to the wiper arms and other components, do not attempt to move the wipers manually.
  • To prevent possible damage to the wipers and washer system, use anti-freezing washer fluids in the winter season or cold weather.

    Operates as follows when the ignition switch is turned ON. 1 2/HI : Fast wiper speed 2 1/LO : Normal wiper speed 3 ---/INT : Wiper operates intermittently at the same wiping intervals.

    The heated washer nozzle function defreeze the washer nozzles in freezing weather. The heated washer nozzle will turn on and off automatically when the ignition switch is in ON or when the engine is running in following conditions: - Turns ON when the outside temperature is below 5°C, and OFF when it is over 10°C.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: License Lamps

    Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp assembly (A) after pressing the locking pin. 3. Disconnect the license lamp connector (A). 4. Remove the license lamp bulb (B) after removing the license lamp socket (A).

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Power Door Lock Module

    Components and components location Components 1. Door lock/unlock knob cable 2. Door inside handle cable 3. Door latch assembly Repair procedures Inspection    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0184