Kia Picanto: AVN System / Speaker
Repair procedures
Troubleshooting of the speakers |
When handling the speakers : •
| Do not cause shock to the speakers by dropping or throwing them. |
•
| Be careful not to drop water and oil on the speakers. |
•
| Use caution to handle the speaker because diaphragm made of paper is easily torn by impact or external force. |
•
| Audio system tuning may cause damage to the speakers. The modified speakers are not covered by the manufacturer’s warranty. |
|
1. | Basic inspection Loosen the screws to rule out the interference from the body trims and surrounding parts and then remove the speaker. After removing the speaker, check the sound quality of the speaker with the connector plugged in. |
2. | Inspection for each cause (1) | Abnormal vibration –
| Make sure the mounting screws are properly tightened before replacing the speaker. |
–
| Reinstall the speaker and check that the symptom is resolved. |
–
| If the symptom does not disappear, replace the speaker with a new one. |
|
(2) | Noise –
| Check that the speaker connector is properly connected and reinstall the connector if necessary. |
–
| If noises occur in the radio mode, turn to the CD player mode. |
–
| If noises occur in both modes, replace the speaker with a new one. |
If noises occur only in the radio mode, the poor radio reception is the cause so do not replace the speaker. |
|
(3) | Poor working –
| Check the plus (+) and negative (-) speaker terminals using an ohmmeter. |
–
| If resistance is measured at the specified value shown below, the speaker operation is normal. |
–
| If the measured resistance is different from the specified value, replace the speaker. |
 |
|
Front Door Speaker
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
3. | Remove the front door speaker (B) after disconnecting the connector (A) and loosening the screws.
 |
Tweeter Speaker
1. | Disconnect the negative (-) battery terminal. |
2. | Using a screwdriver or remover, remove the front door quadrant inner cover (A).
 |
3. | Disconnect the tweeter speaker connector (A).
 |
4. | Remove the tweeter speaker (A) after loosening the mounting screws.
 |
Rear Door Speaker
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
3. | Remove the rear door speaker (B) after disconnecting the connector (A) and loosening the screws.
 |
Front Door Speaker
1. | Install the front door speaker. |
2. | Install the front door trim. |
3. | Connect the negative (-) battery terminal. |
Tweeter Speaker
1. | Install the tweeter speaker. |
2. | Install the front door quadrant inner cover. |
3. | Connect the negative (-) battery terminal. |
Rear Door Speaker
1. | Install the rear door speaker. |
2. | Install the rear door trim. |
3. | Connect the negative (-) battery terminal. |
•
| Make sure that the speaker connectors are plugged in properly. |
•
| Check the AVN system for normal operation. |
|
Components and components location
Components
Connector Pin Information
No.
Connector A
Connector B
...
Components and components location
Components
[Roof Antenna (Radio+GPS/GNSS+DAB+GSM)]
Repair procedures
Removal
Roof antenna
1.Disconnect the negative (-) battery termin ...
Other information:
Description and operation
Description
The
Side Airbags (SAB) are installed inside the front seat and protects the
driver and passenger from danger when side crash occurs. The SRSCM
determines deployment of side airbag by using Side Impact Sensor (SIS)
signal.
N ...
Blade inspection
NOTICE
Commercial hot waxes applied by
automatic car washes have been
known to make the windshield difficult
to clean.
Contamination of either the windshield
or the wiper blades with foreign matter
can reduce the effectiveness of the
windshield wipers. Common source ...